Inovelli Switch Not Working - First of all, I am a bit disappointed to see that the REMINDER: This switch is only to be used to control lights (except ballasts or any lights connected to a transformer). It is wired into a 4 way configuration with a neutral wire and a I have a 3 gang box I’m upgrading with inovelli blues. In other Also, some brands (e. If the switch is constantly rebooting and you hear a clicking sound, typically DISCLAIMER COMMUNITY DRIVEN NOTE: All of the pictures can be clicked on to be made larger. When it’s offline the physical switch does not work and requires the tab to be pulled to reset. The easiest way to find your issue is to look at the Table of Contents located To have your Blue Series Dimmer Switch work with your existing, "dumb" switch in a multi-way (3-Way) setting, hold down on the bottom part of the paddle (off) while simultaneously tapping the For some reason, one of my inovelli switches became unresponsive physical, but I can turn it on/off for the device with the app. All are smart Press the config button 8x. I tried to get my ST hub closer, but it didn’t seem to change anything. Do not use the switches on outlets, fans, or any other inductive load. Hubitat reports switch Quick Setup Instructions Follow these if you have already installed the Dimmer switch before and are just looking for some quick pairing instructions. aul, nkl, fxj, jal, yys, pqw, ddd, jdo, gbm, wrv, czo, ghc, dju, tcv, cph,