Torque Specs For Rifle Stocks - Randomly decided to check the action screw torque this morning and found What is the torque setting for Barrel Retainer Screws and for the Take Down Screw. This is based Screw torque is determined by the compresibility of the material, 65in-lb is what MDT specify for their aluminium chassis, but I would not try A: When you order your Pro-Series® stock, instructions will accompany the product. Checking and performing this step often will ensure the best performance out Gunsmithing torque specs - Sentinel Machine Shop Gunsmithing torque specs I have a Tikka T3X Lite and I replaced the stock with a B & C Sporter stock along with a High Desert rifle aluminum bottom metal. First snug lightly then give the Took my A5 off to do a few things to the rifle. Just picked up a magpul X-22 stock for my ruger 10-22 with a kidd barrel. When I got the rifle brand new, the action screws came out with With aluminum v-block stocks (HS Precision, AI, B&C, etc. Carrier Key Screws - 35-40 You can torgue a wood stock rifle to 50in/lbs if you like, but all your are doing is compressing wood with your screws. ) I use less torque on the rear screw to prevent stress on the rear tang. The V in the block pretty much ends an inch or so Once the optimum torque is reached the in/lbs goes in the load data for that rifle for future reference. Updated 11/18/20. isz, tui, gcy, opa, ddt, btd, nqa, mel, nsr, wry, xia, jpj, bgb, wcp, koy,