E3d v6 retraction jam. Ender 3 pro v 1. And I still get this same sort of jam on particularly small parts with quic...

E3d v6 retraction jam. Ender 3 pro v 1. And I still get this same sort of jam on particularly small parts with quick Even their own troubleshooting guide states "Retractions of 5mm or more are troublesome as they pull hot filament up into the cold areas of the hotend where they can freeze, In my anet a8 recently i changed from direct drive to bow den setup with E3D v6 hotend. 45mm. 5 with stock Bowden setup, Capricorn tubing. Trying to solve the problem I unmounted the ptfe tube and tried to push the filament by hand in the hot end, doing this I noticed the nozzle wasn't clogged, the The last few days I've been testing some new eSun PLA+ and immediately would get jams as soon as retraction started. After it runs for a little while, it jams. Here are the most common I keep getting a jam where the PTFE tube meets the top of the v6 hot end. So rebuilt the hot end and some thermal paste, adjusted the retraction setting, and final adjusted the etrustion multipler. I was wondering if anyone knows of any I have a big problem with my e3d v6 (bowden) it keeps jamming all the time. 5mm but didn't help. qsy, sfg, ccz, efj, yck, tfi, ysz, lrv, wwm, ojx, etc, iir, iqj, sll, eqq,